Datamax M-Class Mark II Manual de inicio rápido - Página 6
Navegue en línea o descargue pdf Manual de inicio rápido para Lector de códigos de barras Datamax M-Class Mark II. Datamax M-Class Mark II 8 páginas. Rfid option
También para Datamax M-Class Mark II: Manual (6 páginas), Manual (8 páginas), Manual de inicio rápido (4 páginas), Manual (10 páginas), Manual de inicio rápido (8 páginas), Manual de inicio rápido (6 páginas)
Imprimir página
Encoded RFID data can also be exported to a host device by enabling OPTION FEEDBACK. This data is
contained in the format <A;B;C;D;E;F>[CR] where:
A -
Is the device type: R = RFID; and, S = Linear Scanner.
B -
Is the resulting status: C = label complete; F = faulted (failed) label; and, U = unknown.
C -
Is the number of expected reads for bar codes or tags, given in two characters.
D -
Is the number of good reads for bar codes or tags, given in two characters.
E -
Is the printer's internal Job and Sub Job Identifier, given in four characters each.
F -
Is the data that was read, delimited with semicolons (;) on multiple reads.
Proceed as follows to capture RFID data:
Step
1
Press MENU.
2
Scroll to COMMUNICATIONS and press ENTER.
3
Scroll to HOST SETTINGS and press ENTER.
4
Scroll to OPTION FEEDBACK and press ENTER.
Select the output format (RFID HEX or RFID ASCII) and press ENTER.
5
Press ESC; and, at the SAVE CHANGES prompt, press ENTER to
6
complete the setup.
Notes: (1) For menu system details, see the Operator's Manual.
(2) Bidirectional communications must also be enabled, and an appropriate cable attached.
Instruction
4
Display