- ページ 6

バーコードリーダー Datamax M-Class Mark IIのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Datamax M-Class Mark II 8 ページ。 Rfid option
Datamax M-Class Mark II にも：マニュアル (6 ページ), マニュアル (8 ページ), クイック・スタート・マニュアル (4 ページ), マニュアル (10 ページ), クイック・スタート・マニュアル (8 ページ), クイック・スタート・マニュアル (6 ページ)

Encoded RFID data can also be exported to a host device by enabling OPTION FEEDBACK. This data is

contained in the format <A;B;C;D;E;F>[CR] where:

A -

Is the device type: R = RFID; and, S = Linear Scanner.

B -

Is the resulting status: C = label complete; F = faulted (failed) label; and, U = unknown.

C -

Is the number of expected reads for bar codes or tags, given in two characters.

D -

Is the number of good reads for bar codes or tags, given in two characters.

E -

Is the printer's internal Job and Sub Job Identifier, given in four characters each.

F -

Is the data that was read, delimited with semicolons (;) on multiple reads.

Proceed as follows to capture RFID data:

Step

Press MENU.

Scroll to COMMUNICATIONS and press ENTER.

Scroll to HOST SETTINGS and press ENTER.

Scroll to OPTION FEEDBACK and press ENTER.

Select the output format (RFID HEX or RFID ASCII) and press ENTER.

Press ESC; and, at the SAVE CHANGES prompt, press ENTER to

complete the setup.



Notes: (1) For menu system details, see the Operator's Manual.

(2) Bidirectional communications must also be enabled, and an appropriate cable attached.

Instruction

Display























