Datapath VSN450 Manual del usuario - Página 9

Navegue en línea o descargue pdf Manual del usuario para Controlador Datapath VSN450. Datapath VSN450 16 páginas. Vsn400 series of wall controllers
También para Datapath VSN450: Manual de inicio rápido (15 páginas)

Imprimir página

Use of the Onboard Graphics Adaptor

Onboard Graphics Adaptor used as Control Screen

The VSN450 is shipped with the BIOS configured to boot off the onboard graphics device. This output can

then be used as the control screen for a typical wall configuration.

To set the system to boot on the onboard graphics device ("Internal Graphics Processing Unit" - IGPU),

enter setup from the boot screen by pressing <DEL> as prompted.

In the BIOS setup utility select:

Advanced Mode>System Agent Configuration>Graphics Configuration> Primary Display [IGPU]

Fig.6

Onboard Graphics Adaptor Disabled

If you do not require a control screen, then you should disable the integrated graphics as described below.

Connect a monitor to the onboard graphics device output and enter setup from the boot screen by

pressing <DEL> as prompted.

In the BIOS setup utility select:

Advanced Mode>System Agent Configuration>Graphics Configuration> Primary Display [PCIE]

If the onboard graphics is disabled, a PCIe graphics device should be installed in slot 1 on the

motherboard, slot 1 is located nearest to the CPU.