Datapath VSN450 사용자 설명서 - 페이지 9

{카테고리_이름} Datapath VSN450에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Datapath VSN450 16 페이지. Vsn400 series of wall controllers
Datapath VSN450에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (15 페이지)

페이지 인쇄
Datapath VSN450 사용자 설명서

Use of the Onboard Graphics Adaptor

Onboard Graphics Adaptor used as Control Screen
The VSN450 is shipped with the BIOS configured to boot off the onboard graphics device. This output can
then be used as the control screen for a typical wall configuration.
To set the system to boot on the onboard graphics device ("Internal Graphics Processing Unit" - IGPU),
enter setup from the boot screen by pressing <DEL> as prompted.
In the BIOS setup utility select:
Advanced Mode>System Agent Configuration>Graphics Configuration> Primary Display [IGPU]
Fig.6
Onboard Graphics Adaptor Disabled
If you do not require a control screen, then you should disable the integrated graphics as described below.
Connect a monitor to the onboard graphics device output and enter setup from the boot screen by
pressing <DEL> as prompted.
In the BIOS setup utility select:
Advanced Mode>System Agent Configuration>Graphics Configuration> Primary Display [PCIE]
If the onboard graphics is disabled, a PCIe graphics device should be installed in slot 1 on the
motherboard, slot 1 is located nearest to the CPU.
9