Datapath VisionRGB-PRO Manual del usuario - Página 11

Navegue en línea o descargue pdf Manual del usuario para Hardware informático Datapath VisionRGB-PRO. Datapath VisionRGB-PRO 19 páginas.

Installing the VisionRGB-PRO

You are likely to need a flat blade and a Phillips head screwdriver for the installation

of the VisionRGB-PRO card; it would be useful to have these to hand before you

begin.

Installing the VisionRGB-PRO is a simple process, follow the steps below to be up

and running in a few minutes:

Power down the PC (including peripherals), switch off at the mains and

disconnect all the cables connected to the computer, noting the positions for

accurate reconnection. Remove the PC cover.

Locate a vacant PCI slot on the motherboard and remove the backing plate

(retain all screws).

Remove the VisionRGB-PRO card from its packaging and secure it firmly into

the empty PCI slot. Extreme care should be taken when sliding the card into

the PCI slot.

Screw the VisionRGB-PRO bracket to the back panel of the PC and replace

the cover.

Connect the cable(s) distributing the RGB signals to the connectors on the

VisionRGB-PRO card located on the back panel. Re-connect all cables to the

PC.

The VisionRGB-PRO2 card has two VGA D-type connectors for two separate,

simultaneous inputs. The top connector is referred to as Channel 1, the bottom

connector, Channel 2. These connections have identical pin outs as illustrated on

the following page.

The VisionRGB-PRO1 also has two VGA D connectors however only the top

connector (Channel 1) can be used for RGB capture.

26 Oct 09