Aussie Pumps MINE BOSS SCUD 351 Manual de instrucciones del operador - Página 9
Navegue en línea o descargue pdf Manual de instrucciones del operador para Bomba de agua Aussie Pumps MINE BOSS SCUD 351. Aussie Pumps MINE BOSS SCUD 351 16 páginas.
También para Aussie Pumps MINE BOSS SCUD 351: Manual de instrucciones del operador (16 páginas)
Jan 2019
CARE AND MAINTENANCE:
AFTER EACH USE
If cleaning agents have been mixed with the incoming
water, it is essential to flush the machine with clean
water after use.
If there is a danger of freezing anti-freeze should be
mixed with the flush water or the machine must be
completely drained.
After the final flush stop the machine. DO NOT allow
the machine to idle for more than 15 seconds. This is
particularly important when there is a danger of
freezing. Do not run for longer without water supply.
STORAGE
Store the washer in an upright position, preferably
drained of water if there is a danger of freezing (or fill
with anti-freeze).
PUMP CRANKCASE LUBRICATION
Proper pressure washer pump crankcase lubrication
will help extend the working life of the machine.
Follow these important guidelines. We recommend
keeping a simple service log book.
Change oil in pump after initial 50 hour run-in
period. (SAE 75W-90)
Change pump oil every 3 months, use high
quality oil. (SAE 75W-90)
Emergency Stop Button
WORK SMART ... STAY SAFE
All Aussie Mine Spec machines
are fitted with an emergency
stop.
This should only be used in an
emergency.
Australian Pump recommends
de-throttling the engine and
running with no load before
shutting off the engine by
turning the key.
| Aussie Scud Mine Boss (Class A) ... Operator's Instruction Manual
Pump oil level can be checked with the
dip stick under the breather cap or by
viewing the oil sight gauge where
fitted. The oil level is correct if level is in the
centre of the gauge. If oil level is low, fill to
correct level with recommended oil (SAE 75W-
90). DO NOT OVERFILL CRANKCASE!
Replace oil in gearbox (separate chamber) with
SAE 90 gear oil every three months.
PREVENTATIVE MAINTENANCE
Keep filter in supply hose connection clean,
rinse regularly.
Use correct size nozzles for machine and
replace when worn, check serial tag for correct
size.
Drain water from pressure hoses, gun/lance
assembly and accessories after use.
Protect pump from freezing. Failure to remove
water from the pump in freezing temperatures
will result in damaged pump manifold.
Use ONLY injector of the size and type
designed for this model.
DO NOT tamper
adjustment or alter engine speed.
DO NOT siphon chemicals through the pump, it
is designed for water only.
Incoming water supply must not exceed 60°C,
otherwise pumps seal damage could result
Follow engine manufactures guidelines for
engine maintenance. (see engine manual)
If the emergency stop button has
been used, it will need to be reset
before the engine will start again.
To
reset,
clockwise.
WARNING
activating the E-stop turn the
ignition key to the OFF position.
Failure to do so could result in a
flat
battery
battery life.
Aussie Pumps
with
unloader
valve
turn
the
button
Immediately
after
and
shortened
9