Agri-Fab 45-0324 Manual del usuario - Página 7

Navegue en línea o descargue pdf Manual del usuario para Esparcidor Agri-Fab 45-0324. Agri-Fab 45-0324 13 páginas. Atv mounted 125 lb. broadcast spreader
También para Agri-Fab 45-0324: Manual del usuario (12 páginas)

Imprimir página
WIRING
INSTRUCTIONS
When properly
connected,
the spreader
motor will run
counterclockwise.
19. Move the spreader's
flow control
lever to the off
position so that the "ON-Off" switch is turned off.
20. Connect the short (fused) wire harness to the vehicle
battery by connecting the red wire to the positive post
and the brown
wire to the negative
post on the
battery. The wire harness may be left permanently
attached to the battery.
See figure 11 .
21. Connect
the long wire harness to the spreader
by
connecting
the red and white wires to the switch and
the brown and white wires to the spreader
motor.
Refer to figure 11.
22. Connect
the long wire harness to the short (fused)
wire harness.
Be sure the wires are clear of any
moving parts, hot engine parts, or pinch points.
23. Use the nylon ties provided
to safely
secure the
wiring away from hot engine parts, rotating parts and
pinch points.
,_
NEVER
allow
negative
pin on plug to
come in contact
with positive
"hot" post
on battery.
Fire or explosion
can result!
RED
SWITCH
"_
_
WHITE
MOTOR
"_ BROWN
FUSE AND HOLDER
RED
POSITIVE
"HOT"POST_+o_
_
I
BATTERY
NEGATIVEPIN
BROWN
FIGURE 11
24. Move the flow control lever to the "ON" position. Flip
the "ON-OFF"
switch on and check that the motor
runs counterclockwise.
If it does not, refer to the
wiring diagram on page 6 and recheck the hookup.
25. Move the flow control lever to "OFF". This should turn
the "ON-OFF"
switch
off. If it does
not, you can
loosen the control and rotate it enough that the flow
control lever, when moved to the "OFF" position will
turn the switch off. See figure 12.
f
FIGURE 12
FLOW CONTROL