Agri-Fab 45-0324 Manual del usuario - Página 9

Navegue en línea o descargue pdf Manual del usuario para Esparcidor Agri-Fab 45-0324. Agri-Fab 45-0324 13 páginas. Atv mounted 125 lb. broadcast spreader
También para Agri-Fab 45-0324: Manual del usuario (12 páginas)

REMOVING THESPREADER
13. Disconnect thespreader f romthevehiclebatteryby
unplugging t heshortwireharness fromthelongwire
harness. T heshortwireharness maybeleftperma-
nentlyattached to the battery.
14. Removethe flow controlfromthe rear rackof the
vehicleif it is attached there.
15. Loosenthe knobsonthe spreadermounting brack-
ets. Rotate
the clamps
fastened
underneath
the
vehicle
rack and lift them up through
the rack to
remove the spreader.
MAINTENANCE
STORAGE
CHECK FOR LOOSE FASTENERS
1.
Before each use make a thorough visual check of the
spreader
for any bolts and nuts which may have
loosened.
Retighten any loose bolts and nuts.
CHECK FOR WORN OF DAMAGED
PARTS
2.
Check for worn or damaged
parts before each use.
Repair or replace parts if necessary.
CLEANING
3.
Rinse inside of hopper and exterior of spreader
and
dry off before storing.
1.
Rinse inside of hopper and exterior of spreader
and
dry off before storing.
2.
Store in a clean, dry area.
TROUBLE
SHOOTING
POINTS
Hopper closure plate does not open to
1. Material packed around plate
1. Clean out around closure plate
the correct position.
Spreader motor doesn't run.
1.
2.
3.
4.
5.
6.
7.
Check and reconnect.
Replace fuse.
Tighten battery terminals.
Recharge the battery.
Replace damaged wiring.
Replace the switch
Repair or replace motor.
Loose connection in spreader wiring
1.
In line fuse is blown.
2.
Loose battery connection
3.
Battery is run down.
4.
Broken spreader wiring
5.
Spreader switch is broken.
6.
Spreader motor is broken.
7.
Wired backwards to battery.
1.
Wired backwards to battery.
1.
Spreader on-off switch is broken.
2.
Spreader motor runs backwards.
1.
Switch wiring at battery terminals.
Motor runs when switch is shut off.
1.
Switch wiring at battery terminals.
2.
Replace the switch.