AUSTRALIAN MADE GREAT MATE Instrucciones de instalación y configuración - Página 12

Navegue en línea o descargue pdf Instrucciones de instalación y configuración para Motor AUSTRALIAN MADE GREAT MATE. AUSTRALIAN MADE GREAT MATE 20 páginas. Double swing gate motor kit

Imprimir página

Connecting the Circuit Board and Fitting the Battery

ALWAYS TURN THE POWER OFF AND DISCONNECT THE BATTERY

BEFORE MAKING ANY WIRING CONNECTIONS

Refer to the "DC 2 Circuit Board" " data sheet included with this manual or to any reference

notes or photos and fit the wires back into the correct terminal locations on the control board.

Fit the battery on its end into the battery space on the drive assembly as shown below.

Battery

Black / Blue wires to black

Negative battery Terminal /

Double piggy back spade

connectors for solar power or

single spade connectors for

transformer power.

It is recommended that the battery be connected first during this stage of the installation. The

primary power source can be connected after all the necessary set-up procedures and

adjustments are made. Refer to the "DC 2 Circuit Board" data sheet included with this manual

and locate the battery connection terminals on the circuit board. Ensure the battery wires are

correctly connected to the correct terminals on the circuit board. Connect the battery wires to the

battery terminals on the battery. Note the polarity (

Black / Blue Negative wires to Black battery terminal). The board should now be powered

and great care should be taken to avoid shorting out or otherwise damaging the circuit board.

Care should be taken as there are moving components inside the gate

motor that may cause damage or personal injury.

GATE MOTOR

INSTALLATION AND SET UP

INSTRUCTIONS

Drive

Assembly

Red

wires to

Red

Battery Terminal / Double piggy

back spade connectors for solar

power or single spade connectors

for transformer power.

Mounting

Cradle

Positive

Red

positive wires to

Battery Wires

Red

battery terminal,