dymax 39380 Manual de instrucciones - Página 11

Navegue en línea o descargue pdf Manual de instrucciones para Equipamiento industrial dymax 39380. dymax 39380 16 páginas. Uv light-curing conveyors – 18" and 25"

Imprimir página

SYSTEM ADJUSTMENTS

SETUP SCREEN

The setup screen allows you to set the blower on

and off delays. Blower delays are factory set and

should not be modified without consulting the

factory. This screen also allows you to reset the

lamp hours when a new lamp is installed.

To access the setup screen from the main

screen, hit the Setup UV Button. This is a

password protected screen. The factory preset

password is 321.

Figure 17. Setup Screen

MAINTENANCE

The conveyor should require little maintenance. It is important

that the Belt be operated under proper tension and alignment.

If it is loose the Belt can slip resulting in Belt and Roller wear

and improper conveyor speed. If the alignment is incorrect,

the Belt can track to one side inducing wear to the side of the

Belt and the Rubber Roller Guides. The conveyor should be

inspected daily to assure that the Belt and Rollers rotate in

phase with one another and that the Belt remains relatively

centered between the two Rubber Roller Guides.

If the Belt requires an adjustment, loosen the Jam Nut and Set

Screw and turn the Adjustment Screw clockwise to increase

Figure 18. Adjustment Screws for Belt Tension

Belt tension. Make this adjustment equally on both sides of

and Alignment

the conveyor to ensure proper Belt tracking. Retighten the

Jam Nuts and locking Set Screws. Do not over-tension the

Belt. Over tensioning can cause tearing of the Belt seam and

damage to other components.

If you remove the high-voltage Irradiator Cable from the Irradiator, use care when replacing it. If the Connector is

not properly seated and tightened, the Irradiator Cable can be ruined by arcing across the Connector.

BELT TRACKING ADJUSTMENT

All Dymax WIDECURE conveyors are adjusted at the factory to provide proper tracking of the Belt. Should

further adjustments become necessary, this is done via two Adjustment Screws located at the input end of the

conveyor. To adjust tracking, simply tighten the side to which the Belt is tracking.

CAUTION:

Do not over tighten the Belt. This will lead to accelerated degradation of the Belt.

Dymax WIDECURE UV Conveyor