5D TACTICAL Router JigPro Manual de instrucciones - Página 6
Navegue en línea o descargue pdf Manual de instrucciones para Herramientas 5D TACTICAL Router JigPro. 5D TACTICAL Router JigPro 13 páginas.
También para 5D TACTICAL Router JigPro: Manual de instrucciones (7 páginas)
Imprimir página
3-2
Set end mill depth to the first hash
mark using Depth Gauge #1. Set
depth by holding the base of Router Adapter
against the edge of the Guide Plate. Be sure
Guide Pins are not between the Adapter
and Guide Plate. Make sure router depth
adjustment is locked after each depth setting.
3-3
Orient Jig so the buffer extension
is closest to the user. Place router
on Guide Plate, with the end mill centered
within the drill hole. The Guide Pins should be
positioned inside the #1 Guide Cavities on both
sides. Hold firmly, turn router on and mill using
consistent pressure and speed, moving in a
clockwise manner.
6
3-4
Complete the first pass of milling,
allowing the Guide Pins to trace
the entire area of the Guide Cavities.
3-5
Set end mill depth to the second
hash mark. Mill second pass
following the same method and process as
outlined in steps 3-3 and 3-4.
3-6
Continue milling in this manner,
adjusting end mill depth 1 hash
mark per pass until you have milled to the
bottom of Depth Gauge #1. STOP Before
continuing to Depth Gauge #2, the #2
(Medium) Guide Pins must be installed.
508-834-4223
5DTACTICAL.COM