GRDIAN Charger Plus Manual del usuario - Página 9

Navegue en línea o descargue pdf Manual del usuario para Equipos de prueba GRDIAN Charger Plus. GRDIAN Charger Plus 18 páginas. Hardwire kit

STEP 3: DETERMINE WHICH FUSES TO USE

CONSTANT & SWITCHED FUSE

BEFORE YOU BEGIN

Make sure your vehicle's electrical system is completely turned OFF before you start.

(Some vehicles may require a couple of minutes of standby for it to completely shut down)

Avoid connecting to fuses over 10A. Use fuses 10A or lower.

DO NOT connect to a fuse relative to car safety (brake lights, cooling fan, TCS, SRS, TPMS,

Fuel Pump, ALT, ECU, etc)

NOTE: Some vehicles maintain their electrical system/power a couple minutes after shutdown.

We recommend opening your doors/trunk for access into your vehicle later. Some vehicles may

require up to ~30 minutes before it completely turns off. Upon returning, avoid opening/closing

any doors or turning on anything. A good indicator of when a vehicle is completely off is when the

cabin lights turn off.

LOCATE A CONSTANT FUSE

1. Set your multimeter to 20 DCV.

2. Use the black lead to touch your ground point.

3. Place the

red

lead on both ends of the fuse. The multimeter should read ~12V.

LOCATE A SWITCHED FUSE

1. Set your multimeter to 20 DCV.

2. Use the black lead to touch your ground point.

3. Place the

red

lead on both ends of the fuse. The multimeter should read ~0V.