GRDIAN Charger Plus 사용자 설명서 - 페이지 9

{카테고리_이름} GRDIAN Charger Plus에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GRDIAN Charger Plus 18 페이지. Hardwire kit

STEP 3: DETERMINE WHICH FUSES TO USE

CONSTANT & SWITCHED FUSE

BEFORE YOU BEGIN

Make sure your vehicle's electrical system is completely turned OFF before you start.

(Some vehicles may require a couple of minutes of standby for it to completely shut down)

Avoid connecting to fuses over 10A. Use fuses 10A or lower.

DO NOT connect to a fuse relative to car safety (brake lights, cooling fan, TCS, SRS, TPMS,

Fuel Pump, ALT, ECU, etc)

NOTE: Some vehicles maintain their electrical system/power a couple minutes after shutdown.

We recommend opening your doors/trunk for access into your vehicle later. Some vehicles may

require up to ~30 minutes before it completely turns off. Upon returning, avoid opening/closing

any doors or turning on anything. A good indicator of when a vehicle is completely off is when the

cabin lights turn off.

LOCATE A CONSTANT FUSE

1. Set your multimeter to 20 DCV.

2. Use the black lead to touch your ground point.

3. Place the

red

lead on both ends of the fuse. The multimeter should read ~12V.

LOCATE A SWITCHED FUSE

1. Set your multimeter to 20 DCV.

2. Use the black lead to touch your ground point.

3. Place the

red

lead on both ends of the fuse. The multimeter should read ~0V.