GRDIAN Charger Plus 사용자 설명서 - 페이지 8

{카테고리_이름} GRDIAN Charger Plus에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GRDIAN Charger Plus 18 페이지. Hardwire kit

STEP 2: LOCATE A GROUND POINT

LOCATING A GROUND POINT

Grounding your wire is crucial to the safety of yourself and your vehicle in the event of a short

circuit. The chassis of your vehicle generally makes a good ground. However, vehicles today are

built with a combination of metals, spot welds, glued together uni-body panels and isolated

chassis components. Therefore, we cannot assume that a good ground will automatically be on

the chassis.

In most vehicles you should be able to locate an obvious ground near the fuse box. Your owner's

manual may even tell you where the factory ground is. If you are unable to locate a ground point,

we'll show you how to locate a ground. There are 2 ways to test your ground point.

TESTING YOUR GROUND POINT

CONTINUITY TEST

[ SET MULTIMETER TO 200 OHMS

1. Set your multimeter to Continuity Test or 200 ohms.

2. Using the black lead, touch the negative (-) terminal of your vehicle's battery

and then place the

beep if it is a complete path. If it does not beep, look for another ground.

RESISTANCE TEST

[ SET MULTIMETER TO

1. Set your multimeter to Resistance Mode or Diode Check.

2. Using the black lead, touch the negative (-) terminal of your vehicle's battery

and then place the

than .2 ohms.

Locate a secure bolt on your chassis. Use your multimeter to test.

red

lead on to your ground point. Your multimeter should

red

lead on to your ground point. A good ground point should read less

]