Aircommand 5860001 Manual Manual - Página 4

Navegue en línea o descargue pdf Manual Manual para Aire acondicionado Aircommand 5860001. Aircommand 5860001 17 páginas. Roof top air conditioner

1. Installation Position

Before beginning, mark out the position of the unit

considering the following important requirements:

• The air conditioner should be situated as centrally as

possible on the van, to ensure even air distribution.

• The Sparrow Mk4 may be oriented in any direction to the

normal direction of travel.

• When considering the installation position remember to

check for clearance around the plenum inside the van.

• Avoid an installation position where a bulkhead, cupboard

or light ﬁ tting could interfere with the discharge air ﬂ ow

from the plenum.

• Avoid an installation where a roof joining seam crosses

through the 14" square installation cut out.

It is important that the unit is never more than 5° from

the horizontal and the rear of the unit should never be

higher than the front when in use.

Contact Aircommand if your installation differs signiﬁ cantly.

• The above outline on the left shows the minimum

clearance required around the Sparrow Mk4 unit on the

roof of the vehicle, distances shown are calculated from a

14" square hole (356 x 356mm).

• The above outline on the right shows the minimum

clearance required around the 14" square hole (356 x

356mm) in order to accommodate the plenum.

Installation

There should be a minimum

of 100mm clearance around

the perimeter of the unit to

allow for service access and

air ﬂ ow to condenser.

Fig 1: Sparrow Mk4 clearances required around roof top unit.

14" x 14" (356mm)

Fig 2: The foot print of the rooftop unit, and the plenum,

measured from the hole.

Hot air is ejected from

this exhaust; consider

nearby roof hatch.

square hole