Hi-Force TWE Series Manual de instrucciones - Página 10
Navegue en línea o descargue pdf Manual de instrucciones para Herramienta eléctrica Hi-Force TWE Series. Hi-Force TWE Series 20 páginas. Electric torque wrench
Imprimir página
Prepared by:-
M.DAVIES
REV NO:-
1
ECO:-
3.1.5 RIGHT / LEFT SWITCH
The direction of rotation of the tool is
permanently indicated by the LED (3) when tool
is switched on.
Push the right/left button to switch rotation
direction, the tool will also emitting a short
sound signal during this operation.
3.1.6 GEAR SETTING
The wrench is calibrated in 1st and 2nd gear mode, therefore choose the respective gear according to the
required selected torque.
1st gear: control knob (9) in position 1
2nd gear: control knob (9) in position 2
Only change gear when the motor is NOT running.
Should the speed selector not engage properly, operate the torque wrench for a short time with no load
applied.
3.1.7 FAST / SLOW MODE
By pressing the <Select> button the operator can
switch between FAST u and STRONG Mode.
By pressing <Select> the chosen selection will
flash three times.
Display: Strong = Str, Fast = Fst
In STRONG Mode the tool operates with less
speed and switches off automatically.
The operator must work in the SLOW/STRONG
Mode, if the bolt is 20% longer than that laid
down in the factory calibration certificate.
In FAST Mode u the tool works with higher
speed.
The operator can work in the FAST Mode u, if
the bolt is the same length as the value laid
down in the factory calibration certificate.
OPERATING INSTRUCTIONS:
Electric Torque Wrench
Series: TWE
Approved by:-
Page 10 of 20
TDS:-
1399
Date: 25/03/14