Hi-Force TWE Series Instrukcja obsługi - Strona 10

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Elektronarzędzie Hi-Force TWE Series. Hi-Force TWE Series 20 stron. Electric torque wrench

Prepared by:-

M.DAVIES

REV NO:-

ECO:-

3.1.5 RIGHT / LEFT SWITCH

The direction of rotation of the tool is

permanently indicated by the LED (3) when tool

is switched on.

Push the right/left button to switch rotation

direction, the tool will also emitting a short

sound signal during this operation.

3.1.6 GEAR SETTING

The wrench is calibrated in 1st and 2nd gear mode, therefore choose the respective gear according to the

required selected torque.

1st gear: control knob (9) in position 1

2nd gear: control knob (9) in position 2

Only change gear when the motor is NOT running.

Should the speed selector not engage properly, operate the torque wrench for a short time with no load

applied.

3.1.7 FAST / SLOW MODE

By pressing the <Select> button the operator can

switch between FAST u and STRONG Mode.

By pressing <Select> the chosen selection will

flash three times.

Display: Strong = Str, Fast = Fst

In STRONG Mode the tool operates with less

speed and switches off automatically.

The operator must work in the SLOW/STRONG

Mode, if the bolt is 20% longer than that laid

down in the factory calibration certificate.

In FAST Mode u the tool works with higher

speed.

The operator can work in the FAST Mode u, if

the bolt is the same length as the value laid

down in the factory calibration certificate.

OPERATING INSTRUCTIONS:

Electric Torque Wrench

Series: TWE

Approved by:-

Page 10 of 20

TDS:-

1399

Date: 25/03/14