Hi-Tech Diamond Slant Cabber Glass/Crystal Manual de instrucciones - Página 10

Navegue en línea o descargue pdf Manual de instrucciones para Sander Hi-Tech Diamond Slant Cabber Glass/Crystal. Hi-Tech Diamond Slant Cabber Glass/Crystal 16 páginas.

Imprimir página

OILING & ARBOR ADJUSTMENTS

The only part you need to oil on the Slant Cabber

machine is the inside of the 2" silver arbor. This is

required because the motor shaft and arbor are

made of different materials. Over time, they can

seize together, making it impossible to remove

the arbor. Every two months or so, remove the

arbor by inserting the included Allen wrench into

the set screw, turning counter-clockwise. Turn the

arbor upside down. Apply a few drops of motor

oil, way oil, lithium or water pump grease into the

area where the arbor fits onto the shaft. Make

sure there is no excess oil so that oil doesn't drip

down the motor shaft and get into the motor.

This will cause an instant motor burn-out. When

putting the arbor back onto the shaft, make sure

the screw is positioned against the flat side of the

motor shaft. If the screw is positioned against the

rounded side of the shaft, it will make a squeak-

ing noise and create friction, causing the motor

shaft to get hot. Once the arbor is positioned

properly, check the set screw for tightness on the

arbor using the Allen wrench. Do not over tighten

the set screw. The arbor may be adjusted up and

down as necessary to keep the spinning disc

below the black spray shield.

Set

screw

MAINTENANCE

Arbor

CLEANING

The Slant Cabber is designed to be easily

cleaned. After each use, flush out the bottom

water reservoir with clean water so the rock

sediment gets washed down the drain tube. Any

used water must not be disposed down a sink, as

it can harden like cement, closing off the drain.

Allow the machine to dry completely then store it

in a safe place, away from children.

Note: When you are finished using the diamond

discs, rinse and spin completely dry. Store them in

a clean, dry plastic bag until next use. Maximum

weight of any discs/laps should not exceed 1.5lbs

on your Slant Cabber machine.

FUSE DETAILS

The fuse is installed in the back of the Slant Cab-

ber machine. It is a 250V, 2AMP slo-blo cartridge

fuse. If you need a replacement, this fuse can be

found at your local hardware store. See below for

how to change the fuse.

Push in with a flat head screwdriver, then turn to the left

(counter-clockwise)