Hi-Tech Diamond Slant Cabber Glass/Crystal Manual de instrucciones - Página 8

Navegue en línea o descargue pdf Manual de instrucciones para Sander Hi-Tech Diamond Slant Cabber Glass/Crystal. Hi-Tech Diamond Slant Cabber Glass/Crystal 16 páginas.

Imprimir página

GRINDING AND POLISHING

STEP 1: ROUGHING

The 360# diamond disc is the coarsest disc that

comes with this Slant Cabber. If you have less than

a millimeter to remove, we suggest skipping this

step and begin at step 2. The 360# disc is required

if you need to remove a large amount of material

from your work piece, or to remove glass left from

the punty. Install the 360# disc according to the

instructions on page 7. Remove material until you

obtain the general shape, size or depth of your

finished piece.

STEP 2: SHAPING

The 600# diamond disc will either create your

first intial shape, or if you started at step 1,

remove the deeper scratches left by the 360# disc

and attain the final shape. Install the 600# disc

according to the instructions on page 7. Remove

material until you have a look simliar to a surface

having been roughly sandblasted.

STEP 3: SMOOTHING

The 1,200# diamond disc will remove scratches

left behind from step 2. Install the 1,200# disc

according to the instructions on page 7. Proceed

to grind until you have a finely frosted surface. A

properly shaped surface is perfectly smooth and

satiny in appearance. Rinsed and dried, you should

not see any scales (aka dimples, facets, flats, etc,)

or scratches. Hold it up to a bright light and look

for deep lines. Scales are most easily observed by

watching the piece dry. Because the "scales" will

have deeper puddles of water, they will evaporate

more slowly. Wet your piece and watch for this

phenomenon. If you see any scratches or scales,

you may not have smoothed long enough. If after

additional smoothing you

360# diamond disc

600# diamond disc

1,200# diamond disc