AFFORDABLE LIFTS KCSPM3648 Manual de montaje e instalación - Página 11
Navegue en línea o descargue pdf Manual de montaje e instalación para Sistemas de elevación AFFORDABLE LIFTS KCSPM3648. AFFORDABLE LIFTS KCSPM3648 15 páginas. Affordable lift
Imprimir página2. The photos below show a Rain Guard installed over the switch.
3. To install the Rain Guard, loosen the Upper Limit Switch set screw, slide the Rain Guard tab down between the Column
and the Upper Limit Switch mounting bracket, as in the photo below. Then tighten the Upper Limit Switch set screw.
11.3. Adjust Your Upper Limit Switch: Raise or lower the Upper Limit Switch to make the Platform stop higher or lower. Use
the 1/8" allen wrench. Note that landings are not always level, nor are their edges always square.
Tip: If your Upper Limit Switch is at a good height and you find you need to temporarily move it, first mark its current
position on the Column for later reference.
12. Anchoring The Armed Base
12.1. Depending on local building codes, anchoring the armed base of a lift of this height may be optional. But we do
recommend it to keep your lift from shifting over time. NOTE: If you use shims then you must also anchor your base to
prevent it from shifting off of your shims.
12.2. Here is how to anchor your Armed Base:
1.
Be sure the Armed Base is exactly where you want it long term. Run your Platform up and down its full travel
to check for any collisions. You may even want to initially anchor your Platform at only two points so that you can later
easily adjust the base location and use the other anchor points. Once anchored at all points, your lift's location will
be very difficult to adjust.
2. Make sure the gates are properly aligned, working and properly interacting with the landing railings.
3. For the measurements below please remember that many walls are not truly vertical. If you are placing your Column
near a wall use a plumb bob to determine the vertical plane of the wall and any obstructions.
4. Use a plumb bob to determine the vertical plane of a landing's edge. Remember that many landings are not square and
many landings are not level.
5. Be sure to also consider water spigots, electrical outlets and other items that might obstruct the path of the Collar or the
Platform itself.