AFFORDABLE LIFTS KCSPM3648 Manual de montaje e instalación - Página 13
Navegue en línea o descargue pdf Manual de montaje e instalación para Sistemas de elevación AFFORDABLE LIFTS KCSPM3648. AFFORDABLE LIFTS KCSPM3648 15 páginas. Affordable lift
Imprimir página14.3. Convenience: If you have a gate that is facing a very close, solid, smooth wall for the Platform's entire travel, the gate
may not be necessary. It may be more convenient for you to remove and store the gate. This is easy to do using a 3/8"
allen wrench.
14.4. Reversing A Gate:
1. You will need a 3/8" allen wrench. Do not use power tools on this step.
2. Unbolt the gate, reverse it and bolt it back on.
3. Do not tighten the gate's hinge bolts. Doing so will prevent the gate from swinging freely.
4. Adjust the gate as needed (see next step).
14.5. Adjusting A Gate:
1. If adjustment is required then use a 9/16" wrench to adjust the horizontal gate adjustment bolts as needed.
2. The latch end of the gate should line up vertically with the adjacent vertical post.
15. Minimize Platform "Twist"
15.1. Platform "Twist": Platform "twist" is the side to side movement of the Platform around the Column's vertical axis. It can
occur as you step onto or off of the Platform when it is elevated. While not dangerous, excessive Platform twist can make
the rider feel uncomfortable.
15.2. Minimizing Platform "Twist": Twist can be minimized by carefully tightening the single Collar bolt on the lower back
Collar. You can reduce the side to side movement of the Platform around the Column's vertical axis by doing the following:
1.
During the adjustment process, if slack develops in the hoist synthetic rope, the Platform may fall violently. Stay
clear of the Platform, and do not allow slack to accumulate in the synthetic rope.
2. Tighten the nylock nut on the 3⁄8-16 x 4.5 bolt at the bottom back of the Collar. Do this in 1⁄4 turn increments.
3. Check the adjustment by confirming that the lift will still descend under its own weight.