Affordable Wheelchair Lifts KCSPM3648 Manual de instalación - Página 10
Navegue en línea o descargue pdf Manual de instalación para Sistemas de elevación Affordable Wheelchair Lifts KCSPM3648. Affordable Wheelchair Lifts KCSPM3648 14 páginas.
También para Affordable Wheelchair Lifts KCSPM3648: Manual del usuario (12 páginas)
Imprimir página_____________________________________________________________________________________
Secondly, we want to set the maximum
Platform height for the lift – the
height level with your landing. This
adjustment is made by raising or
lowering the nut on the metal rod of
the Limit Switch Actuator. (See
Below)
If the Platform stops at your desired height, then tighten the nuts to each other to
prevent them from moving. You have now completed the step of adjusting the lift's
maximum height.
If the Platform stops lower than you want, then shorten the limit switch
actuator to allow the Platform to go higher:
● Determine how many inches higher you want the Platform to actually go.
● Lower the platform a bit to give you some slack to work with.
● (You can do the steps below without removing the Safety Guard. The metal
rod can just slide out once you remove the plastic rod.)
● Shorten the limit switch actuator by the number of needed inches by
lowering the nuts on the metal rod.
● Do not lower the nuts any lower than 2" from the lower end of the metal rod,
or the rod will not be stable it its slot.
● If you cannot lower the nuts enough you can always easily cut the plastic rod
with a knife or saw to be slightly shorter. Do not accidentally cut the plastic
rod too short or else you will need to either replace the plastic rod or purchase
a longer metal rod.
_____________________________________________________________________________________
This metal rod, nut and accompanying plastic tubing is
located behind the Safety Guard and all adjustments can
be made without removing the Safety Guard. The metal
rod can just slide out once you remove the plastic rod.
With the plastic rod seated on the metal rod, carefully use
the controller to raise the platform until the limit switch
stops it. Measure your current Platform height. Then do
one of the following steps. ( Repeat this process until the
Platform stops at the height you desire.)