Affordable Wheelchair Lifts KCSPM3648 Manuel d'installation - Page 10

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Affordable Wheelchair Lifts KCSPM3648. Affordable Wheelchair Lifts KCSPM3648 14 pages.
Également pour Affordable Wheelchair Lifts KCSPM3648 : Manuel du propriétaire (12 pages)

Imprimer la page
_____________________________________________________________________________________
 
Secondly, we want to set the maximum 
Platform height for the lift – the 
height level with your landing. This 
adjustment is made by raising or 
lowering the nut on the metal rod of 
the Limit Switch Actuator. (See 
Below) 
 
 
 
If the Platform stops at your desired height,​ then tighten the nuts to each other to 
prevent them from moving. You have now completed the step of adjusting the lift's 
maximum height. 
 
If the Platform stops lower than you want,​ then shorten the limit switch 
actuator to allow the Platform to go higher: 
● Determine how many inches higher you want the Platform to actually go. 
● Lower the platform a bit to give you some slack to work with. 
● (You can do the steps below without removing the Safety Guard. The metal 
rod can just slide out once you remove the plastic rod.) 
● Shorten the limit switch actuator by the number of needed inches by 
lowering the nuts on the metal rod. 
● Do not lower the nuts any lower than 2" from the lower end of the metal rod, 
or the rod will not be stable it its slot. 
● If you cannot lower the nuts enough you can always easily cut the plastic rod 
with a knife or saw to be slightly shorter. Do not accidentally cut the plastic 
rod too short or else you will need to either replace the plastic rod or purchase 
a longer metal rod. 
 
_____________________________________________________________________________________
This metal rod, nut and accompanying plastic tubing is 
located behind the Safety Guard and all adjustments can 
be made without removing the Safety Guard. The metal 
rod can just slide out once you remove the plastic rod. 
 
With the plastic rod seated on the metal rod, carefully use 
the controller to raise the platform until the limit switch 
stops it. Measure your current Platform height.  Then do 
one of the following steps. ​ ( Repeat this process until the 
Platform stops at the height you desire.)