GREAT PLANES Dynaflite Bird of Time Apéndice del manual - Página 3
Navegue en línea o descargue pdf Apéndice del manual para Juguete GREAT PLANES Dynaflite Bird of Time. GREAT PLANES Dynaflite Bird of Time 6 páginas. Ep arf
Imprimir página
ADDENDUM INSTRUCTIONS
1. The canopy design has been updated to be easily
removable for battery access. The entire Final Assembly
section in the manual booklet (pages 12-13) can be skipped.
To remove the updated canopy, slide it forward and then lift
up on the aft end.
2. Skip the section Install the Tow Hook Mount in the
manual booklet on page 8. The tow hook parts are not
included with the Bird of Time EP.
3. In the section Install the Rudder on page 9 of the manual
booklet, the rudder servo location is now located beneath
the wing saddle (previously mounted in the fuselage nose).
The installation procedure for the servo and pushrod
hardware remain the same.
4. In the section Install the Elevator Linkage beginning
on page 10 of the manual booklet, a CS-5 micro servo is
recommended. However, this model servo is no longer
available. We recommend the Futaba S3154 as a substitute
(see recommendations in the Flight Equipment section of
this addendum). The installation procedure for the servo
and pushrod hardware remains the same.
5. In the section Install the Receiver on page 12 of the
manual booklet, the receiver has been moved from the nose
of the fuselage to just in front of the rudder servo. Shown
here, the receiver is secured to the tray using self-adhesive
hook-and-loop material (not included, use GPMQ4480).
6. Two motor mounting templates are provided on the
other side of this addendum. One is for the recommended
RimFire .32 motor and the other is left blank for use with
other motors. Photocopy, then cut out the template and
temporarily tape it to the fi rewall. Accuracy is important in
this step to ensure that the motor, and therefore spinner too,
are properly centered on the fi rewall.
7. Use something with a sharp tip such as a T-pin to make
indentations onto the fi rewall for the motor mounting holes.