GREAT PLANES Dynaflite Bird of Time Addendum al manuale - Pagina 3

Sfoglia online o scarica il pdf Addendum al manuale per Giocattolo GREAT PLANES Dynaflite Bird of Time. GREAT PLANES Dynaflite Bird of Time 6. Ep arf

ADDENDUM INSTRUCTIONS

1. The canopy design has been updated to be easily

removable for battery access. The entire Final Assembly

section in the manual booklet (pages 12-13) can be skipped.

To remove the updated canopy, slide it forward and then lift

up on the aft end.

2. Skip the section Install the Tow Hook Mount in the

manual booklet on page 8. The tow hook parts are not

included with the Bird of Time EP.

3. In the section Install the Rudder on page 9 of the manual

booklet, the rudder servo location is now located beneath

the wing saddle (previously mounted in the fuselage nose).

The installation procedure for the servo and pushrod

hardware remain the same.

4. In the section Install the Elevator Linkage beginning

on page 10 of the manual booklet, a CS-5 micro servo is

recommended. However, this model servo is no longer

available. We recommend the Futaba S3154 as a substitute

(see recommendations in the Flight Equipment section of

this addendum). The installation procedure for the servo

and pushrod hardware remains the same.

5. In the section Install the Receiver on page 12 of the

manual booklet, the receiver has been moved from the nose

of the fuselage to just in front of the rudder servo. Shown

here, the receiver is secured to the tray using self-adhesive

hook-and-loop material (not included, use GPMQ4480).

6. Two motor mounting templates are provided on the

other side of this addendum. One is for the recommended

RimFire .32 motor and the other is left blank for use with

other motors. Photocopy, then cut out the template and

temporarily tape it to the fi rewall. Accuracy is important in

this step to ensure that the motor, and therefore spinner too,

are properly centered on the fi rewall.

7. Use something with a sharp tip such as a T-pin to make

indentations onto the fi rewall for the motor mounting holes.