GREAT PLANES Tori Manual de instrucciones - Página 12

Navegue en línea o descargue pdf Manual de instrucciones para Aviones GREAT PLANES Tori. GREAT PLANES Tori 20 páginas.

GREAT PLANES Tori Manual de instrucciones

Hook Up the Elevator and Rudder

1. Mount the elevator and rudder servos as shown. (If your
servos do not fi t, the servo tray may be trimmed as necessary.)
Drill 1/16" [1.5mm] holes for the servo mounting screws and
mount the servos with the screws that came with them.
2. Slide one of the small, plastic tubes onto one of the
pushrods. Make a slight bend 2" [50mm] from the back end
of the pushrod.
3. Guide the pushrod down through and out one of the
slots in the boom – the bend in the wire will allow the end of
the wire to poke up through the slot.
4. Straighten the pushrod by removing the bend.
5. Prepare and install the other pushrod through the other
slot in the boom the same way – don't forget to install the
small plastic tube fi rst!
9/32" [7mm]
(2
nd
hole in Tactic
servo arm)
Elevator
6. Same as was done for the aileron servo arms, enlarge
the holes in the elevator and rudder servo arms with a
(.052" [1.3mm]) drill. It may be necessary to trim the servo
arms, but only enough so they don't interfere with the inside
of the fuselage when the arms are on the servos.
7. Fit the pushrods into the holes in the servo arms
indicated in the previous illustration. Temporarily install the
servo arms to the servos.
12
7/16" [11mm]
(4
th
hole in Tactic
servo arm)
Rudder
#55