GREAT PLANES Tori 사용 설명서 - 페이지 12

{카테고리_이름} GREAT PLANES Tori에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GREAT PLANES Tori 20 페이지.

Hook Up the Elevator and Rudder

❏

1. Mount the elevator and rudder servos as shown. (If your

servos do not fi t, the servo tray may be trimmed as necessary.)

Drill 1/16" [1.5mm] holes for the servo mounting screws and

mount the servos with the screws that came with them.

❏

2. Slide one of the small, plastic tubes onto one of the

pushrods. Make a slight bend 2" [50mm] from the back end

of the pushrod.

❏

3. Guide the pushrod down through and out one of the

slots in the boom – the bend in the wire will allow the end of

the wire to poke up through the slot.

❏

4. Straighten the pushrod by removing the bend.

❏

5. Prepare and install the other pushrod through the other

slot in the boom the same way – don't forget to install the

small plastic tube fi rst!

9/32" [7mm]

hole in Tactic

servo arm)

Elevator

❏

6. Same as was done for the aileron servo arms, enlarge

the holes in the elevator and rudder servo arms with a

(.052" [1.3mm]) drill. It may be necessary to trim the servo

arms, but only enough so they don't interfere with the inside

of the fuselage when the arms are on the servos.

❏

7. Fit the pushrods into the holes in the servo arms

indicated in the previous illustration. Temporarily install the

servo arms to the servos.

7/16" [11mm]

hole in Tactic

servo arm)

Rudder

#55