Great White GW9500 Manual del usuario - Página 9
Navegue en línea o descargue pdf Manual del usuario para Aspirador de piscinas Great White GW9500. Great White GW9500 12 páginas. Automatic pool cleaner
Imprimir páginaSeals
Figure 21
Make sure Oscillator
is partially inserted in
chamber while reinstalling
Shaft Assembly
Oscillator
Chamber
Figure 22
Figure 23
Start here with
large button when
installing vacuum skirt.
'Outside' will show
(facing out) when
skirt is correctly installed.
Figure 24
If you have any questions, please call 1-800-752-0183
ABOUT ASSEMBLY
1894 0795
Swing Cam
Arm up for
Clearance
O U
Rubber
T S
I D E
vacuum skirt
1893 0795
1. Put both white seals in the oscillator; hold them in
place.
2. Install the oscillator on the long gear shaft. Install the
ratchet gear on the shaft so that the teeth engage the
ratchet on the oscillator. Install the spring, ratchet
drum, pinion gear (large gear first), and cam (gear end
first) on the shaft (See Figure 21). Hold the gears on the
shaft while installing them, and compress the clutch
spring to allow assembly to slip into place between the
posts (See Figure 21).
3. Install the long gear shaft and end blocks in the clean-
ing head with the large arm of the cam down (see
Figure 22).
4. Reinstall the short gear shaft, set screw and two gears
(See Figure 23); the small pinion gears and the shaft set
screw go on the side toward the end of the cleaner –
away from the oscillator box. Make sure that the gears
engage the gears on the long gear shaft.
5. Install the oscillator chamber cap and clip it in place.
6. Install the rubber vacuum skirt on the cleaner with the
word 'OUTSIDE' showing. Start at the large pin on the
back of the cleaner head (see Figure 24) and work
around the cleaner. Make sure the skirt is flush against
the stop strips on the cleaner head (see Figure 25).
7. Turn the cleaner over. If you removed the bumper and
brush ring, replace them now.
8. Install the lower body assembly in the shroud. Fasten
the cleaning head in place with 4 screws (2 long, 2 short
– see Figure 26).
NOTE: Make sure that you do not dislodge the rubber
vac skirt while inserting the lower body assembly past
the brush ring.
This
Figure 25
#10-16x1-3/4" Screws
Center
Brush
Location
#10-16x1" Screws
Bottom View of Cleaner
Figure 26
9
Not
This
1892 0795
Lift Brush
Location
Center
Brush
Location
1891 0795