DaytonAudio MKBOOM Manual de montaje - Página 4

Navegue en línea o descargue pdf Manual de montaje para Altavoces DaytonAudio MKBOOM. DaytonAudio MKBOOM 10 páginas. Mkboom bluetooth powered speaker kit

Imprimir página

5. Next, locate the two 2-way Pre-Wired Crossover Boards. Cut the small white connector off of the red and black

wires and strip the wires back roughly 1/2".

6. Once the glue is dry you can install a crossover board into each speaker cavity using four #6 x 3/4" Deep Thread

Pan Head Screws Black. We recommend placing them in the center of the bottom panel inside each left/right

enclosure. Ensure that each foam-wrapped speaker wire lead can reach the holes in the baffle. The red (+) and

black (-) wires go to the woofer, the blue (+) and black (-) wires go to the tweeter. The crossovers can be secured

with the included wood screws. BE CAREFUL NOT TO OVERTIGHTEN SCREWS.

7. Remove the 4-conductor Speaker Wire Harness from the amplifier package (#1 in the amplifier wiring diagram)

and feed the two +/- conductors into each speaker chamber through the small holes in the internal walls. Leave

enough slack in the center cavity to be able to plug the harness into the amplifier, roughly 8-10".

8. Using the wiring diagram below, solder the left and right channels of the wire harness to each crossover

observing polarity. Use heat shrink to cover the soldered connections.