DaytonAudio MKBOOM Manual de montaje - Página 6

Navegue en línea o descargue pdf Manual de montaje para Altavoces DaytonAudio MKBOOM. DaytonAudio MKBOOM 10 páginas. Mkboom bluetooth powered speaker kit

Imprimir página

13. Insert the Power (green/black wires), Bluetooth (blue/black wires), and Charging (red/black wires) LED's into the

panel by removing the nut and lock washer from each LED and insert, wire first, through the corresponding holes

in the front of the panel. Add a lock washer then nut to each LED and secure nuts with included Wrench.

14. Locate the Aux Input And Cable and Push Button And Cable For Bluetooth Pairing. Remove the nuts and

washers and install into the corresponding holes in the panel. Use fingers or needle nose pliers to tighten nuts.

15. Locate the Volume Control, Knob, and 6 Conductor Cable. Pull off the knob, remove the nut and washer, and

plug one end of the cable into the corresponding cable on the volume control. Insert the volume control into the

corresponding hole from the back of the panel and install the washer then nut. Tighten the nut using the included

wrench. Turn the splined shaft on the knob all the way to the left and attach the knob so it is pointing at the

bottom left hash mark.

Tip: The volume control is keyed. Make sure the volume control is installed properly so it sits flat and will not

spin freely.

16. Locate the On-Off Switch And Cable and DC Input And Cable. Remove the nut and lock washer from the DC input

and install the jack in the corresponding hole in the panel. Add the lock washer then nut and tighten nut using the

supplied wrench. Install the On-Off switch through the front of the panel and press until it snaps into place.

Tip: The On-Off switch is keyed and can only be installed one way.