Greatneck 80161 Manual del usuario - Página 11

Navegue en línea o descargue pdf Manual del usuario para Sierra Greatneck 80161. Greatneck 80161 18 páginas. High speed circular saw

Imprimir página

CHANGING THE BLADE

WARNING:

plug from the power source before

removing the blade or adjusting the saw

in any way.

Press inward on the shaft locking

button (1) (Fig. 1).

Fig. 1

Insert 5 mm hex key into the blade

screw (2) (Fig. 2). While pressing in the

shaft locking button (Fig. 1), rotate the

hex key counter clockwise until the

shaft locking button engages the blade

shaft. Continue turning the hex key

counter clockwise to remove the blade

screw, lock washer (3), flat washer (4)

and large outer flange washer (5).

ASSEMBLY AND OPERATION

Always remove the

Fig. 2

Open the blade guard by lifting upward

on the blade guard lever (6) (Fig. 3).

Rotate the blade guard in a clockwise

direction to expose the blade (7).

While holding the blade guard lever in

the open position, lift the blade (7) off

the shaft (8) and slide it out through the

slot in the sole plate (9) (Fig. 4).

NOTE: Do NOT remove the inner large

flange washer.

WARNING:

handling the blade. It is sharp and can

easily cut your hand.

To place a new blade onto the motor

shaft, rotate the blade guard forward

(Fig.3) and slide the blade through the

slot in the sole plate until it fits over the

motor shaft (Fig. 4).

NOTES:

a) Make sure the blade teeth are

pointing forward at the bottom of the

blade.

b) Make sure the hole in the blade is

placed over the matching boss on the

inner large flange washer.

4 5

0 ° °

Fig. 3

Use caution when

Fig. 4