Greatneck 80161 소유자 매뉴얼 - 페이지 11
{카테고리_이름} Greatneck 80161에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Greatneck 80161 18 페이지. High speed circular saw
페이지 인쇄
CHANGING THE BLADE
!
WARNING:
plug from the power source before
removing the blade or adjusting the saw
in any way.
1.
Press inward on the shaft locking
button (1) (Fig. 1).
Fig. 1
2.
Insert 5 mm hex key into the blade
screw (2) (Fig. 2). While pressing in the
shaft locking button (Fig. 1), rotate the
hex key counter clockwise until the
shaft locking button engages the blade
shaft. Continue turning the hex key
counter clockwise to remove the blade
screw, lock washer (3), flat washer (4)
and large outer flange washer (5).
ASSEMBLY AND OPERATION
Always remove the
Fig. 2
3.
Open the blade guard by lifting upward
on the blade guard lever (6) (Fig. 3).
Rotate the blade guard in a clockwise
direction to expose the blade (7).
6
4.
While holding the blade guard lever in
the open position, lift the blade (7) off
the shaft (8) and slide it out through the
slot in the sole plate (9) (Fig. 4).
NOTE: Do NOT remove the inner large
flange washer.
!
WARNING:
handling the blade. It is sharp and can
easily cut your hand.
5.
To place a new blade onto the motor
shaft, rotate the blade guard forward
(Fig.3) and slide the blade through the
slot in the sole plate until it fits over the
motor shaft (Fig. 4).
NOTES:
a) Make sure the blade teeth are
pointing forward at the bottom of the
blade.
b) Make sure the hole in the blade is
placed over the matching boss on the
inner large flange washer.
11
4 5
0 ° °
Fig. 3
Use caution when
Fig. 4