GAI-Tronics 234WM-202 Manual del usuario - Página 8
Navegue en línea o descargue pdf Manual del usuario para Teléfono de emergencia GAI-Tronics 234WM-202. GAI-Tronics 234WM-202 13 páginas. Wall-mount stanchion assembly
Imprimir páginaModel 234WM-202 Wall-Mount Stanchion Assembly
Emergency Telephone Installation
1. Separate the back box from the front panel of the telephone. The parts envelope inside the back box
contains eight #6-32 self-tapping flat head screws, six tamperproof screws, six washers, and a hole
plug.
2. Place the back box into the telephone opening from the front of the stanchion. Mount the box using
four of the #6-32 self-tapping flat head screws. Refer to Figure 7 below. The telephone back box has
two openings, one in the top and one in the bottom. Plug the top opening with the hole plug. The
bottom of the back box is the recommended entry location for the telephone line and strobe control
wires.
3. Install a telephone line surge suppressor (sold separately) on the protection bracket on the bottom of
the stanchion wall-mounting assembly. See Figure 3.
4. Install a ground wire between the telephone line surge suppressor (sold separately) and the grounding
lug on the bottom of the stanchion. See Figure 8
5. Connect the telephone line to the surge protection as shown in Figure 8.
p:\standard ioms - current release\42004 instr. manuals\42004-308g.docx
04/16
Figure 7. Telephone and Back Box Installation
Pub. 42004-308G
Page 8 of 11