GAI-Tronics 234WM-202 사용자 설명서 - 페이지 8

{카테고리_이름} GAI-Tronics 234WM-202에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GAI-Tronics 234WM-202 13 페이지. Wall-mount stanchion assembly

Model 234WM-202 Wall-Mount Stanchion Assembly

Emergency Telephone Installation

1. Separate the back box from the front panel of the telephone. The parts envelope inside the back box

contains eight #6-32 self-tapping flat head screws, six tamperproof screws, six washers, and a hole

plug.

2. Place the back box into the telephone opening from the front of the stanchion. Mount the box using

four of the #6-32 self-tapping flat head screws. Refer to Figure 7 below. The telephone back box has

two openings, one in the top and one in the bottom. Plug the top opening with the hole plug. The

bottom of the back box is the recommended entry location for the telephone line and strobe control

wires.

3. Install a telephone line surge suppressor (sold separately) on the protection bracket on the bottom of

the stanchion wall-mounting assembly. See Figure 3.

4. Install a ground wire between the telephone line surge suppressor (sold separately) and the grounding

lug on the bottom of the stanchion. See Figure 8

5. Connect the telephone line to the surge protection as shown in Figure 8.

p:\standard ioms - current release\42004 instr. manuals\42004-308g.docx

04/16

Figure 7. Telephone and Back Box Installation

Pub. 42004-308G

Page 8 of 11