Automatic Technology Australia GDO-8 v1 EasyRoller II Manual de instrucciones de instalación - Página 14
Navegue en línea o descargue pdf Manual de instrucciones de instalación para Abrepuertas de garaje Automatic Technology Australia GDO-8 v1 EasyRoller II. Automatic Technology Australia GDO-8 v1 EasyRoller II 20 páginas.
Imprimir página9. SETTING TRANSMITTERS CODES
Make sure to insert the battery into the transmitters. The
memory in the openers receiver can store up to eight remote
control transmitters.
10.1 STORING THE TRANSMITTERS CODE
1. Press and hold the Door Code button (Fig. 14).
2. Press the button (one of four) on the transmitter you would
like to use to control the door for two seconds, pause for two
seconds. Press the same button again on the transmitter for
two seconds.
3. Release the Door Code button.
4. Press the transmitter button to test if it operates the door.
10. STORING TRANSMITTER(S) FROM A
REMOTE LOCATION
Using this method you don't need to have access to the
control panel on the Door Opener. However, you do need a
transmitter that is pre coded to the controller's receiver.
IMPORTANT NOTE: The door must be activated when the
step below is performed. The moving door confirms that the
correct button was pressed and the transmitter was in range
of the opener.
1. Take any pre-coded transmitter. Press the button for the
function you require until the door is activated and release.
2. Using a small needle press the button through the Coding
Hole for two seconds (Fig. 15)
3. Within 10 seconds take the additional transmitter you wish
to code.
4. Press the button (one of four) on the new transmitter you
would like to use to control the door for two seconds, pause
for two seconds. Press the same button again on the
transmitter for two seconds, the button should now be
stored.
5. Wait for 10 seconds and then test the new transmitter
to see if it operates the door.
11. DELETING PROGRAMMED CODES
11.1 DELETING A STORED TRANSMITTER CODE
1. Select the transmitter you want to delete.
2. Press and hold the Door Code button (Fig. 14).
3. Press the transmitter button you would like to delete for two
seconds. Pause for two seconds. Press the transmitter
button again for two seconds.
4. Release the Door Code button. The code should now be
deleted. Confirm this by pressing the transmitter button, the
door should not respond.
CODING TRANSMITTERS
Press and hold
Door Code
Button
11.2 DELETING ALL STORED TRANSMITTER CODES
1. Turn the power off to the opener.
2. Press and hold the Door Code button (Fig. 14).
3. Turn the power on again while holding the Door Code
button. The Open Limit, Close Limit and Door Status LED's
will illuminate for about five seconds. These LED's will turn
Off and the Coding LED will illuminate. Release the Door
Code button. All the stored codes should now be deleted.
Confirm this by trying to operate the door by pressing the
transmitters previously used to control the door, the door should
not respond.
12. LOCKING THE CONTROL PANEL
To lock or disable the control panel a transmitter button must be
coded specifically for this purpose.
1. Press and hold Door Code and Plus (+) button together.
2. Select the transmitter button you wish to use to lock the
control panel.
3. While holding Door Code and Plus (+) press transmitter button
twice. Release all buttons.
4. To test press the coded transmitter button for four (4) seconds.
The control panel should now be locked. Press the Operate
button to confirm that the door does not move.
To unlock the control panel press the transmitter button for four (4)
seconds.
14
FIG. 14
Select one of the four
buttons you wish to use
to control the door.
FIG. 15