Automatic Technology Australia GDO-8 v1 EasyRoller II Manuale di istruzioni per l'installazione - Pagina 14

Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Apriporta del garage Automatic Technology Australia GDO-8 v1 EasyRoller II. Automatic Technology Australia GDO-8 v1 EasyRoller II 20.

Stampa la pagina

9. SETTING TRANSMITTERS CODES

Make sure to insert the battery into the transmitters. The

memory in the openers receiver can store up to eight remote

control transmitters.

10.1 STORING THE TRANSMITTERS CODE

1. Press and hold the Door Code button (Fig. 14).

2. Press the button (one of four) on the transmitter you would

like to use to control the door for two seconds, pause for two

seconds. Press the same button again on the transmitter for

two seconds.

3. Release the Door Code button.

4. Press the transmitter button to test if it operates the door.

10. STORING TRANSMITTER(S) FROM A

REMOTE LOCATION

Using this method you don't need to have access to the

control panel on the Door Opener. However, you do need a

transmitter that is pre coded to the controller's receiver.

IMPORTANT NOTE: The door must be activated when the

step below is performed. The moving door confirms that the

correct button was pressed and the transmitter was in range

of the opener.

1. Take any pre-coded transmitter. Press the button for the

function you require until the door is activated and release.

2. Using a small needle press the button through the Coding

Hole for two seconds (Fig. 15)

3. Within 10 seconds take the additional transmitter you wish

to code.

4. Press the button (one of four) on the new transmitter you

would like to use to control the door for two seconds, pause

for two seconds. Press the same button again on the

transmitter for two seconds, the button should now be

stored.

5. Wait for 10 seconds and then test the new transmitter

to see if it operates the door.

11. DELETING PROGRAMMED CODES

11.1 DELETING A STORED TRANSMITTER CODE

1. Select the transmitter you want to delete.

2. Press and hold the Door Code button (Fig. 14).

3. Press the transmitter button you would like to delete for two

seconds. Pause for two seconds. Press the transmitter

button again for two seconds.

4. Release the Door Code button. The code should now be

deleted. Confirm this by pressing the transmitter button, the

door should not respond.

CODING TRANSMITTERS

Press and hold

Door Code

Button

11.2 DELETING ALL STORED TRANSMITTER CODES

1. Turn the power off to the opener.

2. Press and hold the Door Code button (Fig. 14).

3. Turn the power on again while holding the Door Code

button. The Open Limit, Close Limit and Door Status LED's

will illuminate for about five seconds. These LED's will turn

Off and the Coding LED will illuminate. Release the Door

Code button. All the stored codes should now be deleted.

Confirm this by trying to operate the door by pressing the

transmitters previously used to control the door, the door should

not respond.

12. LOCKING THE CONTROL PANEL

To lock or disable the control panel a transmitter button must be

coded specifically for this purpose.

1. Press and hold Door Code and Plus (+) button together.

2. Select the transmitter button you wish to use to lock the

control panel.

3. While holding Door Code and Plus (+) press transmitter button

twice. Release all buttons.

4. To test press the coded transmitter button for four (4) seconds.

The control panel should now be locked. Press the Operate

button to confirm that the door does not move.

To unlock the control panel press the transmitter button for four (4)

seconds.

FIG. 14

Select one of the four

buttons you wish to use

to control the door.

FIG. 15