GReddy Turbo Kit Manual de instalación - Página 10

Navegue en línea o descargue pdf Manual de instalación para Accesorios para automóviles GReddy Turbo Kit. GReddy Turbo Kit 18 páginas. 96-98 nissan 240sx s14 (ka24de) td06-20g 8cm2
También para GReddy Turbo Kit: Manual de instalación (13 páginas), Manual de instalación (18 páginas)

Imprimir página

3-3 Oil Pressure Line Installation

1. Remove the factory oil pressure switch at the

left side of the rear rotor housing and install the

Oil pressure line using the provided 3 way

fitting, and straight fitting. Route the line to the

right side of the engine (over the transmission)

to connect to the turbo in the later step.

Apply Teflon tape on the PT thread in and

to not over tighten the fitting.

Wrap the oil pressure line with the

provided wire loom.

3-4 Turbocharger Install

1. Remove the e-clip and two bolts and remove

the actuator off from the turbocharger.

2. Install the provided oil pressure fitting with

copper washer and oil return gasket with one

mounting bolt as shown.

3. Install the provided stud bolts to the manifold

and turbine as shown.

4. Place the turbocharger up by the engine, and

while holding the turbo to the side, install the

exhaust manifold to the engine.

*Use factory gasket

(Parts Used #1)

(Parts Used #22, 26, 48, 63)

(Parts Used #2, 66)