Gree 13-04686 Manual de instrucciones - Página 7
Navegue en línea o descargue pdf Manual de instrucciones para Aire acondicionado Gree 13-04686. Gree 13-04686 20 páginas.
Imprimir página
10. Clamp plastic window panel between a
board and a work table, and cut along cut-
ting line with a fine tooth saw. Remove any
burrs with a file.
11. Fasten side channels to the sides of the
AC using 3 screws (Item 17) per channel.
Start with first screw at top of channel.
Make sure hook ends of channels face
toward back of unit.
12. Slide plastic window panel into panel
frame, with the smooth side to the room.
Slide panel frame assembly into side chan-
nels of the AC cabinet. Make sure plastic
window panel is firmly enclosed on all sides
by the retainer grooves.
13. Cut side channel seal into 2 equal
lengths. Remove protective backing and
apply it to the rear side of cabinet side
channels, starting just below panel frame
assembly. Pinch off excess length so seal is
even with the bottom of the cabinet side
channel.
14. To remove front
1. Remove the two front retaining screws
from the front frame.
2. Press firmly on each side of the metal
case close to the front, approximately 2/3 of
the way down.
3. While pressing on the sides of the metal
case, gently pull the front out and lift up to
release it from the case.
4. Then remove the four screws from the
front frame to release the control panel box.
NOTE: DO NOT push or pull air direction
louvers.
15. Place AC in window opening. As shown
right, it should sit on platform assembly so
that window panel frame, and cabinet side
channels are against top and side window
jambs.
(continued)
Fastening Side
Channels
Panel frame
Plastic window
panel
Apply weather seal to
side channels just
below edge of panel
frame.
Screw
Front
retaining
screw
Slide inner
window sash
firmly against
Cabinet.
7