Gree 13-04686 Manual de instrucciones - Página 9

Navegue en línea o descargue pdf Manual de instrucciones para Aire acondicionado Gree 13-04686. Gree 13-04686 20 páginas.

Imprimir página

1. Controls

Installing the Unit in a Casement Window

NOTE: Open the window the maximum

amount to allow for clearance of the cabi-

net. The crank handle should be removed to

allow the platform to be fastened to the

jamb. If the window cannot open far

enough (more than 15-1/2 inches) for the

cabinet to clear the window, remove the

window entirely by drilling out the rivets.

Bolts can serve as the pivots in the future.

To avoid crank handle and window clear-

ance problems, the unit can be installed in a

stationary sash section. However, the hori-

zontal mullion and the

2 glass panels must be removed before

installation.

1. Attach support brace to platform as

shown. Use the adjustment bolt and hex

flange nut to complete the assembly. Choose

the slot and adjustment bolt hole locations

that will create a 45 degree angle between

the platform and the support brace. Try the

assembly in the window to determine if the

platform will rest properly, and allow the

proper slope (3/16- inch lower on outside).

NOTE: If you are planning to use a siding

protection board (see Step 6) on the outside

of your house, hold the board in place when

testing the assembly in the window.

2. Drill a 9/64-inch diameter pilot hole in

the window jamb an equal distance from

each side of the jamb, and 3/16-inch up

from the window sill. If the hole coincides

with the window lever slot in the jamb bot-

tom, an additional hole will have to be

drilled through the platform edge and the

window jamb to miss this slot.

3. Peel off the protective backing from the

track seal, and stick the seal to the win-

dow sill on the outside of the bottom

jamb.

4. Screw the platform assembly to the win-

dow jamb through the pilot hole you drilled

in Step 2. Use a #8x3/4-inch self-threading

screw.

(continued)

1/4" (6mm) HEX

FLANGE NUT

Equal distance from both sides

8 11/16 po

Apply track seal to the outside edge of the

bottom window jamb.

Track seal

Screw

Window

jamb

Platform Assembly