Hideaway Concelo CRL160D Instrucciones de instalación - Página 3
Navegue en línea o descargue pdf Instrucciones de instalación para Electrodomésticos de lavandería Hideaway Concelo CRL160D. Hideaway Concelo CRL160D 5 páginas.
Imprimir página6 of 12mm
Surefix Screw
Step 1 – Marking door panel for template
• Mark a vertical centre line on the rear of the door panel (a).
• Mark a horizontal line indicating the inside top edge of the
carcase for door overlap (b).
TIP: An allowance needs to be made for the door overlap with the top
of the carcase e.g. for a 16mm thick carcase material and 3mm gap
between the door panel and the bench top the horizontal line should
be (16-3) = 13mm down from the top edge of the door panel (b).
NOTE: If the unit is to be positioned higher in the cabinet trim the
required amount off the top of the template. Trimming the template
will adjust the mounting hole positions for both the collar and
runner installation so they remain correctly aligned.
The maximum amount that can be trimmed off is up to:
CRL160 - 40mm.
Step 2 – Pre-drill door panel
• Align the door panel template with the lines as indicated and
mark the 6 mount holes (RED) through the template.
• Drill a 2mm pilot hole at each of the 6 mounting locations.
TIP FOR FRAMED DOORS: 3 screw locations are required for each
door bracket. An alternative location for the top screw is accessible
by removing the door bracket from the collar side. This should be
used in framed door situations and should be inserted after step 5
of the Installation Instructions. Refer overleaf for instructions.
Step 3 – Install collar side sub-assemblies
Refer to Fig. 3
3.1 - Position collar side assemblies.
3.2 - Secure each using 12mm Surefix screws provided.
Step 4 – Install collar rear panel on to collar sides
Refer to Fig. 3
4.1 - Position collar rear panel as shown.
4.2 - Secure using 6g x 12mm self-tapping screws.
NOTE: do not use impact driver or high torque setting.
6 of 6G x 12mm
Self-tapping
Screw
1 of 4mm
Allen Key
(Fig 1/2)
(Fig 2)
Concelo Laundry CRL160D
Collar Assembly Instruction Sheet
Read all instructions before installing this bin unit.
Failure to install the bin correctly may void warranty.
Left hand collar
assembly
FIG.1
(b)
(a)
FIG.3
Collar Rear
Panel
Right hand
collar
assembly
Collar rear panel
Right hand
collar
assembly
FIG.2
Left hand
collar
Collar Side Sub Assembly
assembly