Hideaway Concelo CRL160D 설치 지침 - 페이지 3

{카테고리_이름} Hideaway Concelo CRL160D에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Hideaway Concelo CRL160D 5 페이지.

페이지 인쇄

6 of 12mm

Surefix Screw

Step 1 – Marking door panel for template

• Mark a vertical centre line on the rear of the door panel (a).

• Mark a horizontal line indicating the inside top edge of the

carcase for door overlap (b).

TIP: An allowance needs to be made for the door overlap with the top

of the carcase e.g. for a 16mm thick carcase material and 3mm gap

between the door panel and the bench top the horizontal line should

be (16-3) = 13mm down from the top edge of the door panel (b).

NOTE: If the unit is to be positioned higher in the cabinet trim the

required amount off the top of the template. Trimming the template

will adjust the mounting hole positions for both the collar and

runner installation so they remain correctly aligned.

The maximum amount that can be trimmed off is up to:

CRL160 - 40mm.

Step 2 – Pre-drill door panel

• Align the door panel template with the lines as indicated and

mark the 6 mount holes (RED) through the template.

• Drill a 2mm pilot hole at each of the 6 mounting locations.

TIP FOR FRAMED DOORS: 3 screw locations are required for each

door bracket. An alternative location for the top screw is accessible

by removing the door bracket from the collar side. This should be

used in framed door situations and should be inserted after step 5

of the Installation Instructions. Refer overleaf for instructions.

Step 3 – Install collar side sub-assemblies

Refer to Fig. 3

3.1 - Position collar side assemblies.

3.2 - Secure each using 12mm Surefix screws provided.

Step 4 – Install collar rear panel on to collar sides

Refer to Fig. 3

4.1 - Position collar rear panel as shown.

4.2 - Secure using 6g x 12mm self-tapping screws.

NOTE: do not use impact driver or high torque setting.

6 of 6G x 12mm

Self-tapping

Screw

1 of 4mm

Allen Key

(Fig 1/2)

(Fig 2)

Concelo Laundry CRL160D

Collar Assembly Instruction Sheet

Read all instructions before installing this bin unit.

Failure to install the bin correctly may void warranty.

Left hand collar

assembly

FIG.1

(b)

(a)

FIG.3

Collar Rear

Panel

Right hand

collar

assembly

Collar rear panel

Right hand

collar

assembly

FIG.2

Left hand

collar

Collar Side Sub Assembly

assembly