Auton 3000-INV Manual de instalación - Página 4

Navegue en línea o descargue pdf Manual de instalación para Sistemas de elevación Auton 3000-INV. Auton 3000-INV 6 páginas.

Continued

Adjust Motor and Limit Switch Continued

Limit switches are preset at the factory for optimal positioning and performance, but they may be changed.

Two adjusting screws for the limit are located at the end of the motor. The

top

travel, the

screw controls the closed travel.

Using a power tool to adjust the limits will void the warranty.

1. to increase open travel:

travel.

2. to increase closed travel:

down travel.

Run the lift in the opposite direction for approximately 6" and stop. The motor will recognize the adjustment.

NOTE:

When adjusting the limit switches, turn the adjusting screw in very small increments so

over-adjustment doesn't occur. Each full turn of the screw corresponds to 3/8" in travel.

*The motor is equipped with a built-in thermal overload protection system. In the event the lift (motor) is moved

too frequently in a short period of time, the unit will be disabled to prevent overheating and possible damage.

The unit will automatically re-set itself within 10-15 minutes.

caution:

Dropping or jarring unit by hitting walls, ceilings,

or other objects may cause misalignment of lift.

bottom

counter

turn the

screw

top

counter

turn the

screw

bottom

screw controls the open

clockwise; turn clockwise to decrease the