Auton 3000-INV 설치 매뉴얼 - 페이지 4
{카테고리_이름} Auton 3000-INV에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Auton 3000-INV 6 페이지.
페이지 인쇄Continued
Adjust Motor and Limit Switch Continued
Limit switches are preset at the factory for optimal positioning and performance, but they may be changed.
Two adjusting screws for the limit are located at the end of the motor. The
top
travel, the
screw controls the closed travel.
Using a power tool to adjust the limits will void the warranty.
1. to increase open travel:
up
travel.
2. to increase closed travel:
down travel.
3.
Run the lift in the opposite direction for approximately 6" and stop. The motor will recognize the adjustment.
NOTE:
When adjusting the limit switches, turn the adjusting screw in very small increments so
over-adjustment doesn't occur. Each full turn of the screw corresponds to 3/8" in travel.
*The motor is equipped with a built-in thermal overload protection system. In the event the lift (motor) is moved
too frequently in a short period of time, the unit will be disabled to prevent overheating and possible damage.
The unit will automatically re-set itself within 10-15 minutes.
caution:
Dropping or jarring unit by hitting walls, ceilings,
or other objects may cause misalignment of lift.
-
+
-
+
bottom
counter
turn the
screw
top
counter
turn the
screw
bottom
screw controls the open
clockwise; turn clockwise to decrease the
clockwise; turn clockwise to decrease the