909 254CMS Manual de instrucciones - Página 12

Navegue en línea o descargue pdf Manual de instrucciones para Sierra 909 254CMS. 909 254CMS 19 páginas. 1800w 255mm (10") single bevel laser guided compound mitre saw

Imprimir página

Spindle lock button

The spindle lock button (18)

prevents the blade in the

saw from rotating (Fig. L).

Depress and hold the spindle

lock button while installing,

changing, or removing the

blade.

Rotating lower

blade guard

The rotating lower blade

guard (5) provides

protection from both sides of

the blade (Fig. M). It retracts

over the upper fixed blade

guard (4) as the saw is

lowered into the workpiece.

Dust bag

The dust bag (24) fits over

the dust extraction port (21).

For more efficient operation,

empty the dust bag when it

is no more than half full. This

allows better air flow through

the bag (Fig. N).

Attaching the side bars

The side support bars (29) help to support the material when

working with long workpieces. There are two location holes

(22) for a support bar on either side of the table. Loosen

the lock screws (25) with the 6 mm hex key. Ensure the

side bars are fully inserted before using them to support the

workpiece (Fig. O). The side support bar locking screws (25)

must be tightened to secure the support bars in position

(Fig. P).

Turning on and off

1. Pull the On/Off switch trigger

(16) in (Fig. Q).

2. To turn the saw off release

the On/Off switch trigger

(16).

To lower the blade pull the

guard release lever, which

allows the head to be

lowered.

Turning on the laser

line generator

The laser line generator emits

an intense narrow beam of

pure red light to guide you as

you cut. It improves operator

cutting vision, enables faster

set-up, increases accuracy

and improves safety. To turn

on the laser line press the

laser light On/Off switch (27) (Fig. R). To turn off the laser

press the laser light on/off switch (27) again.