Hifonics Zeus ZXi8006 Manual - Página 7

Navegue en línea o descargue pdf Manual para Amplificador de coche Hifonics Zeus ZXi8006. Hifonics Zeus ZXi8006 15 páginas.

Imprimir página
Hifonics Zeus ZXi8006 Manual
ZXi4406 / ZXi6406 4 CHANNEL AMPLIFIER APPLICATIONS
2 way active, or bi-amplified system with mono bass
This application shows how easily a 2 way active system can be implemented using
This application shows how easily a 2 way active system can be implemented using
a Zeus 4 channel amplifier. Channels 1 and 2 will be used for highs, and channels 3
a Zeus 4 channel amplifier. Channels 1 and 2 will be used for highs, and channels 3
and 4 for mono bass.
and 4 for mono bass.
Interconnect cable checklist:
Interconnect cable checklist:
- We need to feed the same signal to both sets of channels, so must use 2 Y-adapters,
- We need to feed the same signal to both sets of channels, so must use 2 Y-adapters,
one to feed the LEFT signal to channels 1 and 3, and the right signal to channels 2
one to feed the LEFT signal to channels 1 and 3, and the right signal to channels 2
and 4, as shown.
and 4, as shown.
Mono bass woofer wiring:
Mono bass woofer wiring:
- Connect the mono speaker positive terminal to the LEFT +, and its negative
- Connect the mono speaker positive terminal to the LEFT +, and its negative
terminal to RIGHT -.
terminal to RIGHT -.
Switch setting checklist:
Switch setting checklist:
- 1/2CH X-OVER:
- 1/2CH X-OVER: HI
HI
- 3/4CH X-OVER:
- 3/4CH X-OVER: LP/BP
LP/BP
Crossover frequency control checklist:
Crossover frequency control checklist:
Channels 1/2:
Channels 1/2:
- HI PASS: 100 Hz
- HI PASS: 100 Hz
- LOW PASS: N/A
- LOW PASS: N/A
LEFT TO CHANNELS 1 AND 3
RIGHT TO CHANNELS 2 AND 4
B OOS T
H FR - 3
M I N
M A X X
2 way active, or bi-amplified system with mono bass, and faded highs/lows
Here we present a variation of the previous system. Since this is a 2 way system, we
Here we present a variation of the previous system. Since this is a 2 way system, we
can use the front outputs from a head unit to drive the highs, and the rear output to
can use the front outputs from a head unit to drive the highs, and the rear output to
drive the bass This method allows the listener to easily adjust the relative levels of
drive the bass This method allows the listener to easily adjust the relative levels of
bass to highs, with the front to rear fade on the head unit.
bass to highs, with the front to rear fade on the head unit.
Channels 1 and 2 will be used for highs, and channels 3 and 4 for mono bass.
Channels 1 and 2 will be used for highs, and channels 3 and 4 for mono bass.
FULL RANGE
STEREO LINE
INPUTS
B OOS T
H FR - 3
M I N
M A X X
Channels 3/4:
Channels 3/4:
- HI PASS (subsonic): 20 Hz
- HI PASS (subsonic): 20 Hz
- LOW PASS: 100 Hz
- LOW PASS: 100 Hz
Please note that these frequency points are suggestions only. Refer to the
Please note that these frequency points are suggestions only. Refer to the
loudspeaker manufacturer specifications and the section "Setting up systems after
loudspeaker manufacturer specifications and the section
installation for best performance"
installation for best performance"
Level control checklist:
Level control checklist:
Refer to the section "Setting up systems after installation for best performance"
Refer to the section
"Setting up systems after installation for best performance"
Minimum final loudspeaker impedances:
Minimum final loudspeaker impedances:
- 2 ohm per channel in stereo mode.
- 2 ohm per channel in stereo mode.
- 4 ohm mono bridged.
- 4 ohm mono bridged.
Interconnect cable checklist:
Interconnect cable checklist:
- Use good quality RCA leads to connect the inputs of the amplifier to the source as
- Use good quality RCA leads to connect the inputs of the amplifier to the source as
shown.
shown.
- Follow the instructions as per the previous system for switch and crossover
- Follow the instructions as per the previous system for switch and crossover
settings.
settings.
"Setting up systems after
MONO
BASS
SPEAKER
STEREO HIGH
SPEAKERS
TO BATTERY +12v
VIA FUSE
REMOTE TURN-ON
CHASSIS GROUND
MONO
OR SUB BASS
SPEAKER
STEREO
FULL RANGE
OR HIGHS
SPEAKERS
TO BATTERY +12v
VIA FUSE
REMOTE TURN-ON
CHASSIS GROUND
5