909 52299 Manual del usuario - Página 10

Navegue en línea o descargue pdf Manual del usuario para Inversor 909 52299. 909 52299 20 páginas. 3500w inverter generator with pure sine wave

Imprimir página

General Assembly

3. With the supplied 10mm tube spanner (30) still

holding the hex head screw securely in place,

apply the flat washer, spring washer, then the nut

to the top of the hex head screw and tighten in a

clockwise direction using the supplied multi-size

spanner (33) (Fig E).

4. Repeat the same process for the other 3 feet (28).

The generator can now be operated with the

generator sitting on the ground or operating

surface on the four rubber feet (28).

Portable Wheeled Type

Generator Assembly

This generator is supplied with 2 wheels to assist

with transportation, which require the following

assembly:

1. Remove the cover of the wheel by holding one of

the spokes of the outside cover on the wheel, and

pulling towards you until the cover disengages

and can be removed.

2. Insert the bolt through the outside of the wheel

through to the other side, then follow the bolt

through the hole in the corner frame of the

generator (Fig F).

3. Using the 21mm spark plug tube spanner (31)

to secure the bolt head in position, apply the

nut onto the end of the bolt and tighten in a

clockwise direction using the multi size spanner

(33) (Fig G). Repeat for the second wheel.

e-mail: [email protected]

MODEL: №. INF3800A • 52299

3500W Digital Inverter with Pure Sine Wave

AFTER SALES SUPPORT

1800 909 909

(toll free)

3500W Digital Inverter with Pure Sine Wave

Following assembly of the wheels, it is

recommended to assemble the additional wheel

foot (3) for stability and to keep the generator on a

level surface.

1. Raise the opposite end of the generator that the

wheels have been assembled on by placing a

wooden block (or something similar) underneath

the bracket that the feet have been assembled on

(Fig B).

2. Insert the supplied hex head screw through the

bottom of the foot so it comes out the opposite

side (Fig H).

Using the supplied 10mm tube spanner (30), insert

into the foot and engage the head on the hex

head screw. Thread the hex head screw into the

large boss on the base frame cross member on the

handle end of the generator (Fig I). Tighten firmly.

Assembly of the Folding Carry Handle

This generator is supplied with a folding carry handle

(6) to assist with transportation when wheeling the

generator around on the wheels.

1. Align the holes on each bracket of the carry handle

with the holes on each side of the generator frame

(Fig J).

2. With the handle in position, insert each screw

through the outer bracket of the handle, then

through the holes in the generator frame, and

through to the opposite side of the internal

bracket of the handle.

3. Secure the handle into position by applying the

nyloc nuts onto the screws and securing

finger tight.

Using the supplied double ended screwdriver

(phillips head) (32) to hold the screw, then use the

multi size spanner (33) in a clockwise direction to

secure the nyloc nut in place (Fig K).