High-End Technology F16 Manual de instrucciones de montaje - Página 5
Navegue en línea o descargue pdf Manual de instrucciones de montaje para Juguete High-End Technology F16. High-End Technology F16 18 páginas. High-end technology f16 for electric ducted fan
Imprimir páginaImportant:
Before you glue the plywood control horn in place with 5 minute epoxy treat the
surface and holes of the plywood control horn by "soaking" it with thin CA glue.
This will add additional strength to the control horn.
This applies for all 4 plywood control horns.
Mark the location and size of the control horn just after the pivot tube on the bottom.
Now cut out the slot with a sharp Xacto-knive or use a dremel tool. Do not glue the
control horn in place yet. This should be done after you have made the push rod.
Before you glue the servo brackets in place, trial fit your servo (min. 2kg torque with
metal gear), 2 micro servos are necessary. Also pre-drill the holes for the servo
fastening screws. Also make the pushrods first with a z-bend at each end. How to
make this z-bend is explained on page 7.