- ページ 5

おもちゃ High-End Technology F16のPDF 組み立て説明書をオンラインで閲覧またはダウンロードできます。High-End Technology F16 18 ページ。 High-end technology f16 for electric ducted fan

Important:

Before you glue the plywood control horn in place with 5 minute epoxy treat the

surface and holes of the plywood control horn by "soaking" it with thin CA glue.

This will add additional strength to the control horn.

This applies for all 4 plywood control horns.

Mark the location and size of the control horn just after the pivot tube on the bottom.

Now cut out the slot with a sharp Xacto-knive or use a dremel tool. Do not glue the

control horn in place yet. This should be done after you have made the push rod.

Before you glue the servo brackets in place, trial fit your servo (min. 2kg torque with

metal gear), 2 micro servos are necessary. Also pre-drill the holes for the servo

fastening screws. Also make the pushrods first with a z-bend at each end. How to

make this z-bend is explained on page 7.