High-End Technology Flying Wing Manual - Página 5

Navegue en línea o descargue pdf Manual para Juguete High-End Technology Flying Wing. High-End Technology Flying Wing 8 páginas.

Pull an extension servo wire through the

pre-drilled hole. Please use metal gear

servo's. Don't forget to set the servo horn in

its middle position with your transmitter

before you install the servo

Check the alignment of the hinges so that

they are exactly in the middle . Do this for

the elevon and the wing. Correct the pre-cut

slots if neccesary .

In stall the clevises and pushrods

Solder the servo wires to the extension cable

and isolate the wires with shrinktube.

If you use extension cords with male and

female ends you don't have to do soldering.

Than glue the hinges in the elevon and wing

with Thin CA glue

Now install the controll horn on the elevon

Set the elevon 5-6mm up.