High-End Technology Flying Wing 매뉴얼 - 페이지 5

{카테고리_이름} High-End Technology Flying Wing에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. High-End Technology Flying Wing 8 페이지.

Pull an extension servo wire through the

pre-drilled hole. Please use metal gear

servo's. Don't forget to set the servo horn in

its middle position with your transmitter

before you install the servo

Check the alignment of the hinges so that

they are exactly in the middle . Do this for

the elevon and the wing. Correct the pre-cut

slots if neccesary .

In stall the clevises and pushrods

Solder the servo wires to the extension cable

and isolate the wires with shrinktube.

If you use extension cords with male and

female ends you don't have to do soldering.

Than glue the hinges in the elevon and wing

with Thin CA glue

Now install the controll horn on the elevon

Set the elevon 5-6mm up.